INSTALLATION INSTRUCTIONS SPIN DR. - CE-Air International Ltd

INSTALLATION INSTRUCTIONS
Spin Dr.

UNPACK BOX AND LAY OUT COMPONENTS. DO NOT HANDLE SPIN DR. BY PLASTIC FLINGER. wpe24D.jpg (3866 bytes)

PLACE SPIN DR ON BUSHING AND ALIGN MOUNTING HOLES. MAKE SURE THE SPIN DR. ADAPTOR FLANGE SITS SQUARELY ATOP THE HEADS OF THE BUSHING MOUNTING CAP SCREWS.

INSERT CAP SCREWS THROUGH THE ADAPTOR AND INTO BUSHING. START THREADING SCREWS UNTIL THEY ARE HAND TIGHT.

MAKE SURE THE ADAPTOR IS FLUSH WITH THE HEADS OF THE BUSHING SCREWS.

TIGHTEN EACH BOLT 1 1/2 TURNS. WORKING IN A ROTATIONAL PATTERN, CONTINUE TO TIGHTEN EACH BOLT. TORQUE EACH BOLT TO 25 FTXLBS. wpe251.jpg (3563 bytes)
wpe253.jpg (3458 bytes)

USING A CABLE CLAMP, ATTACH ONE END OF THE CABLE TO THE CLUTCH OF THE SPIN DR.

ATTACH THE OTHER END OF THE CABLE TO A STURDY SUPPORT. WE SUGGEST ATTACHING THE CABLE TO AN EYEBOLT (NOT INCLUDED) MOUNTED INTO THE FRAME. LEAVE ABOUT 1/2 INCH OF SLACK IN THE CABLE.

MAINTENANCE:
Periodically check the dain holes located on the adaptor plate. Make sure there is no obstructions in the holes so water may drain out.

The clutch on the SPIN DR. is permantently sealed. There is no maintenance required with this part.

If you have an questions, please contact:

CE-AIR INTERNATIONAL LTD
CE-Air Building • Newton Moor Industrial Estate
Newton, Hyde, SK14 4LG, United Kingdom
Phone: +44 (161) 368-1476 • Fax: +44 (161) 367-8145 • E-mail: sales@ceair.f9.co.uk

BACK TO SPIN DR. BROCHURE

UNPACK BOX AND LAY OUT COMPONENTS. DO NOT HANDLE SPIN DR. BY PLASTIC FLINGER.
PLACE SPIN DR ON BUSHING AND ALIGN MOUNTING HOLES. MAKE SURE THE SPIN DR. ADAPTOR FLANGE SITS SQUARELY ATOP THE HEADS OF THE BUSHING MOUNTING CAP SCREWS.
INSERT CAP SCREWS THROUGH THE ADAPTOR AND INTO BUSHING. START THREADING SCREWS UNTIL THEY ARE HAND TIGHT.
MAKE SURE THE ADAPTOR IS FLUSH WITH THE HEADS OF THE BUSHING SCREWS.
TIGHTEN EACH BOLT 1 1/2 TURNS. WORKING IN A ROTATIONAL PATTERN, CONTINUE TO TIGHTEN EACH BOLT. TORQUE EACH BOLT TO 25 FTXLBS.
USING A CABLE CLAMP, ATTACH ONE END OF THE CABLE TO THE CLUTCH OF THE SPIN DR.
ATTACH THE OTHER END OF THE CABLE TO A STURDY SUPPORT. WE SUGGEST ATTACHING THE CABLE TO AN EYEBOLT (NOT INCLUDED) MOUNTED INTO THE FRAME. LEAVE ABOUT 1/2 INCH OF SLACK IN THE CABLE.
MAINTENANCE: Periodically check the dain holes located on the adaptor plate. Make sure there is no obstructions in the holes so water may drain out. The clutch on the SPIN DR. is permantently sealed. There is no maintenance required with this part.